Points To Check Before A Hot Water Installation
Hot water system is an essential in every household regardless of the current seasons. The demand of hot water is always there. Hot water installation is a technology to get hot water supply as and when needed for domestic usage. It has been widely used pertaining to its necessity. Mainly hot water installations are divided into storage and continuous types. In the former, heated water is stored in tanks or other facilities whereas, in the later, supply is available all the time.
Types Of Water Heater Based On The Energy Consumption
The water heaters at homes differs based on the type of the energy they consume. Further based on the type of energy consumed for heating the water, they are broadly classified below:
#1. Electric: Here, the necessary energy required for heating water is obtained from electricity. According to a survey, almost 23% of total energy consumption in a household is towards heating water. Further, it is not so cheap but has fewer greenhouse emissions.
#2. Solar: Solar energy is trapped in panels that facilitate the heating of water. This heated water is stored in the tanks for later use. The tanks are insulated from the inside for preventing heat escape which ensures faster heating. It is the most expensive hot water installation among all types but releases the least amount of greenhouses gases and is highly energy efficient.
#3. Gas: Natural gas or LPG can be used for instantaneous heating effects. There is higher greenhouse gas emission in the Gas type of hot water installation. Also, the number of units of gas required to heat the stored water is higher than the routine domestic supply.
Major Points To Verify Before You Purchase A Water Heater
Before finalising a hot water installation, some important facts are to be taken care of. Depending on these criteria, it will be quite easy to decide which one would suit the best. In the below section, the relevant points have been briefly elaborated:
#1. Location: The geographic location and landscape are important factors to decide the suitable hot water installation. In terrains, the sunlight usually stays longer whereas, in hillside places, solar-type installation may not be a good choice. There is always a drawback for the areas receiving hard water. It is better to install a filter before you connect the water line to the heater.
#2. Product quality: Get only the best quality product, build for the long run, and survive the tough condition. Since it is a one-time investment, there should not be any compromise on the quality of the buy. Check for the product specifications to the function and the properties of the system.
#3. Repair or maintenance service: Any machine is likely to get complaints and minor trouble after usage. The provision to repair and maintenance should be checked beforehand. The service-providers location should be in the vicinity or they should be available to take calls round the clock.
#4. Savings on power consumption: The electricity consumption or non-renewable energy consumption should be kept at a minimum for avoiding unwanted billings. In short, the product should be economical and energy-friendly in terms of power consumption. This will make you responsible for saving the environment.
#5. Market research: It is always wiser to make a self-survey about the best product available in the market. The customer reviews, company profile and services, and most importantly your needs. By combining all these, simple research could land into buying a preferred hot water system for your family.
Nevertheless, to meet this requirement a hot water installation is needed. After going through the types of hot water systems and the essential features a hot water system should have, it is an easy choice. Give your family important support for everyday working and activity by this installation. A user-friendly product will provide long time satisfaction and meet all demands expect from it.